Titus “HD” Rock Injector vs the Oslo Point

Extensive research was conducted in1989 by TROW and ASSOCIATES at 4 different sites across Northern Ontario. TITUS ROCK INJECTOR POINTS …… TITUS STANDARD POINTS and the OSLO design point were driven into hard bed rock consisting of precambrian igneous and metamorphic lithologies and were in some cases driven into extreme sloping rock up to 45 degrees. Column loads ranged from 120 tons to 450 tons. A total of 575 piles were driven of which approximately 3% were pulled at each test sites.

The Oslo Design
    Oslo Points

  • Channel welded to web of pile and split point welded to channel
  • The protruding case hardened tip upon reaching “Refusal” produced eccentric loading on the bearing pile
  • The case hardened tip … specified at 50-55 rockwell … proved to be extremely brittle and was subject to failure
  • The hardened tip experienced twisting, shearing and bending including bending of the supporting bracket
  • The Oslo Points did not seat and all were deflected off steeply sloping rock.
Titus Rock Injector
    Rock Injector

  • The TITUS ROCK INJECTOR is all case hardened steel.
    At 78 lbs it is 3 times the mass and weight of the Oslo point
  • The web and flanges are fully supported to distribute
    The load to the bearing pile
  • The INJECTOR POINT is similar to a sharp rock drill which Is chipped into the rock face and firmly seats the bearing pile
  • The TITUS ROCK INJECTOR seated firmly on all sloping rock up to 45 degrees. There was no shearing or bending
  • The TITUS ROCK INJECTOR replace all the Oslo points and some of the Titus Standard points.
  • All the TITUS POINTS were driven to within 4% of plumb.

Full Research Paper Available On Request

© 2017 Wear Resistant Steel, Steel Plate Fabrication, Impact Steel Toronto, Mould Steels Titus Steel Co. All Rights Reserved.
1-888-564-7904 • (905) 564 2446 • fax (905) 564 2450 • sales@titussteel.com